Eugene Maker Space Forums
Various Discussions...

Home » Public Forums » Discuss » I'd like to use the black Free-Standing Router Table (with the yellow tag).. Chris or Eric maybe?
I'd like to use the black Free-Standing Router Table (with the yellow tag).. Chris or Eric maybe? [message #14834] Fri, 21 September 2018 01:20 Go to next message
Karen Englebeck is currently offline  Karen Englebeck
Messages: 73
Registered: September 2017
Member
I'm sorry that I've completely forgotten whether it was Chris's or Eric's
machine..I'm still so terrible with the names of people I don't see super
regularly. I forgot to actually check the tag before I left the shop
tonight!

I've been working on my arcade machine project, and I'm reaching the point
where doing the slotting for the T-molding needs to happen soon. I've never
used a router table before, but I'm familiar with the general concept (I've
been using the CNC router table extensively though).

Since the free-standing router table is yellow tagged (the one that's kind
of nestled in the cluster of other tools in the middle of the shop), I know
I need to ask permission first.. so "may I please use it?" I'm going to be
out at the shop tomorrow afternoon and during Open Hack if you'd like to
stop by and make sure I know what I'm doing first, but I can also go
through a couple of instructional youtube videos too.

I'm going to be picking up the slot cutting set from Harbor Freight
tomorrow, and i
...

Re: I'd like to use the black Free-Standing Router Table (with the yellow tag).. Chris or Eric maybe? [message #14835 is a reply to message #14834] Fri, 21 September 2018 08:34 Go to previous message
normgr00 is currently offline  normgr00
Messages: 160
Registered: December 2012
Location: United States
Senior Member
If it's the one with the short table legs, stands about a foot and a half off the ground you can use it. I think the router is a Craftsman brand. I left that one at the Maker Space after I moved to Portland. Use it and if it is a redundant piece of equipment sell it in a fund raze or give it away. 
Greg
On Friday, September 21, 2018, 1:21:07 AM PDT, Karen Englebeck wrote:

I'm sorry that I've completely forgotten whether it was Chris's or Eric's machine..I'm still so terrible with the names of people I don't see super regularly. I forgot to actually check the tag before I left the shop tonight!

I've been working on my arcade machine project, and I'm reaching the point where doing the slotting for the T-molding needs to happen soon. I've never used a router table before, but I'm familiar with the general concept (I've been using the CNC router table extensively though).

Since the free-standing router table is yellow tagged (the one that's kind of nestled in the cluster of other tools in the middle
...

Previous Topic: Want to learn how to use the big CNC table at the shop? Come on down Tuesday night!
Next Topic: eugenemakerspace.com mailing list memberships reminder
Goto Forum:
  


Current Time: Wed Feb 20 16:36:19 PST 2019

Total time taken to generate the page: 0.07327 seconds